●アクセスポイントの型番
CISCO  AIR-LAP1142N


●interfases設定

auto lo eth0
iface lo inet loopback
iface eth0 inet static
           address xxx.xxx.xxx.xxx
           netmask xxx.xxx.xxx.x
           network xxx.xxx.xxx.x
           broadcast xxx.xxx.xxx.xxx
           gateway xxx.xxx.xxx.x
iface awlan0 inet static
           address xxx.xxx.xxx.x
           netmask xxx.xxx.xxx.x
           broadcast xxx.xxx.xxx.xxx
           network xxx.xxx.xxx.x
           gateway xxx.xxx.xxx.x
           pre-up iwpriv awlan0 set_psk パスフレーズキー
           pre-up iwpriv awlan0 set_cryptmode WPA2-AES
           pre-up iwconfig awlan0 essid SSID
           wireless-mode managed









●awl13-firmware-load.shの設定
#!/bin/sh

WLAN=$1
FIRMWARE_SDIO=$(ls -1v /lib/firmware/awl13/fwimage*_SDIO.bin | tail -1)
FIRMWARE_USB=$(ls -1v /lib/firmware/awl13/fwimage*_USB.bin | tail -1)

[ -f /sys/module/awl13_sdio/$WLAN/firmware ] && \
cat $FIRMWARE_SDIO > /sys/module/awl13_sdio/$WLAN/firmware
[ -f /sys/module/awl13_usb/$WLAN/firmware ] && \
cat $FIRMWARE_USB > /sys/module/awl13_usb/$WLAN/firmware
iwpriv $WLAN fwload
iwpriv $WLAN fwsetup

ifdown eth0
ifup awlan0