Hermit-At v3.10.0 (armadillo4x0) compiled at 10:50:55, Mar 28 2019

Lineo Warp!! 5.1.0 (Armadillo440 1.0.1) Tue Nov 13 11:27:55 JST 2018
 Supported: NOR

Snapshot ID : 3b64d44a
Bootflag dev: (NOR ,  0,  0), offs: 0x0000000001ec0000
Snapshot dev: (NOR ,  0,  0), offs: 0x00000000014a0000
Snapshot total size: 0x0143c000   compressed size: 0x00843a50
--- Read Snapshot (compress:2) ---
78000000
Warp!! snapshot load completed.
PM: suspend of devices complete after 5.681 msecs
PM: late suspend of devices complete after 1.350 msecs
PM: noirq suspend of devices complete after 1.623 msecs
dram save 5146 pages
maxarea 0x000817d7(0x00003c7f)  lowmem_maxarea 0x000817d7(0x00003c7f)
zonetbl 3  exttbl 1  dramtbl 575
PM: noirq resume of devices complete after 1.221 msecs
PM: early resume of devices complete after 1.235 msecs
imx-sdma imx25-sdma: loaded firmware 1.0
PM: resume of devices complete after 108.278 msecs
Restarting tasks ... done.
usb 2-1: new high-speed USB device number 2 using ci_hdrc
asix 2-1:1.0 eth1: register 'asix' at usb-ci_hdrc.1-1, ASIX AX88178 USB 2.0 Ethernet, 8c:ae:4c:ff:d6:b1
armadillo4x0_wm8978 armadillo4x0_wm8978.0: ASoC: CODEC wm8978.2-001a not registered
armadillo4x0_wm8978 armadillo4x0_wm8978.0: snd_soc_register_card failed (-517)
platform armadillo4x0_wm8978.0: Driver armadillo4x0_wm8978 requests probe deferral
armadillo4x0_wm8978 armadillo4x0_wm8978.0: ASoC: CODEC wm8978.2-001a not registered
armadillo4x0_wm8978 armadillo4x0_wm8978.0: snd_soc_register_card failed (-517)
platform armadillo4x0_wm8978.0: Driver armadillo4x0_wm8978 requests probe deferral
ifup: interface lo already configured
ifup: interface eth0 already configured
IPv6: ADDRCONF(NETDEV_UP): eth1: link is not ready
ip: RTNETLINK answers: File exists
[root@armadillo440-0 (ttymxc1) /etc/config]# ArmRelay Version 02.01.00
PortNumber : 10940
eth1 IP Address : 192.168.1.101
IPv6: ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
asix 2-1:1.0 eth1: link up, 100Mbps, full-duplex, lpa 0xCDE1