U-Boot SPL 2023.04-at8 (Sep 19 2025 - 03:48:22 +0000) Normal Boot ELE firmware version 1.0.0-344acb84 upower_apd_inst_isr: entry upower_init: soc_id=48 upower_init: version:11.11.13 upower_init: start uPower RAM service user_upwr_rdy_callb: soc=b user_upwr_rdy_callb: RAM version:12.17 Turning on switches... Turn on switches ok Turning on memories... Turn on memories ok Clearing DDR retention... Clear DDR retention ok drive: OD SEC0: RNG instantiated WDT: Started m33-at-wdt with servicing every 1000ms (60s timeout) Trying to boot from BOOTROM Boot Stage: Primary boot image offset 0x0, pagesize 0x200, ivt offset 0x0 Load image from 0x52800 by ROM_API NOTICE: BL31: v2.8(release):2023.04-at8 NOTICE: BL31: Built : 03:48:22, Sep 19 2025 NOTICE: upower_init: start uPower RAM service NOTICE: user_upwr_rdy_callb: soc=b NOTICE: user_upwr_rdy_callb: RAM version:12.17 I/TC: I/TC: Non-secure external DT found I/TC: OP-TEE version: 2023.04-at8 (gcc version 10.2.1 20210110 (Debian 10.2.1-6)) #1 Fri Sep 19 03:48:22 UTC 2025 aarch64 I/TC: Primary CPU initializing I/TC: Primary CPU switching to normal world boot U-Boot 2023.04-at8 (Sep 19 2025 - 03:48:22 +0000) M33 Sync: OK CPU: i.MX8ULP(Dual 5) rev1.2 at 800MHz CPU current temperature: 39 Reset cause: POR Boot mode: Single boot Model: Atmark-Techno Armadillo-900 DRAM: Hold key pressed for tests: t (fast) / T (slow) 992 MiB Core: 52 devices, 24 uclasses, devicetree: separate WDT: Started m33-at-wdt with servicing every 1000ms (60s timeout) MMC: FSL_SDHC: 0, FSL_SDHC: 2 Loading Environment from MMC... OK In: serial Out: serial Err: serial SEC0: RNG instantiated switch to partitions #0, OK mmc0(part 0) is current device mu rx timeout rtc_rv8803_disarm_alarm i2c read flag failed, err -110 mu rx timeout flash target is MMC:0 Net: eth0: ethernet@29950000 Fastboot: Normal Normal Boot Hit any key to stop autoboot: 0 switch to partitions #0, OK mmc0(part 0) is current device 23058944 bytes read in 2083 ms (10.6 MiB/s) mu tx timeout wdt ping failed! expect reboot! (-110) cyclic function m33-at-wdt took too long: 14540us vs 3000us max Booting from mmc ... 40011 bytes read in 22 ms (1.7 MiB/s) Loading fdt boot/armadillo.dtb Working FDT set to 83000000 137 bytes read in 9 ms (14.6 KiB/s) 6153 bytes read in 11 ms (545.9 KiB/s) Applying fdt overlay: armadillo_iotg_a9e.dtbo 2959 bytes read in 10 ms (288.1 KiB/s) Applying fdt overlay: armadillo_iotg_a9e-lbes5pl2el.dtbo 2395 bytes read in 9 ms (259.8 KiB/s) Applying fdt overlay: armadillo_iotg_a9e-sim7672.dtbo 1246 bytes read in 10 ms (121.1 KiB/s) Applying fdt overlay: armadillo_iotg_a9e-at-dtweb.dtbo ## Flattened Device Tree blob at 83000000 Booting using the fdt blob at 0x83000000 Working FDT set to 83000000 Using Device Tree in place at 0000000083000000, end 000000008304cfff Working FDT set to 83000000 Delete node /soc@0/bus@2d800000/epdc@2db30000 Delete node /soc@0/bus@2d800000/epxp@2db40000 mu tx timeout Starting kernel ... [ 0.000000] Booting Linux on physical CPU 0x0000000000 [0x411fd040] [ 0.000000] Linux version 5.10.238-at0 (atmark@atde9) (aarch64-linux-gnu-gcc (Debian 10.2.1-6) 10.2.1 20210110, GNU ld (GNU Binutils for Debian) 2.35.2) #1 SMP PREEMPT Tue Oct 7 09:22:38 JST 2025 [ 0.000000] Machine model: Atmark-Techno Armadillo-IoT Gateway A9E Board [ 0.000000] earlycon: lpuart32 at MMIO32 0x0000000029390000 (options '') [ 0.000000] printk: bootconsole [lpuart32] enabled I/TC: Secondary CPU 1 initializing I/TC: Secondary CPU 1 switching to normal world boot [ 0.172127] fsl-edma-v3 29010000.dma-controller: Can't get mp clk. [ 0.327759] i.MX clk 10: register failed with -19 [ 0.332238] i.MX clk 11: register failed with -19 [ 0.351284] clk: failed to reparent lpuart4 to frosc_div2: -16 [ 0.447421] Unable to handle kernel paging request at virtual address ffff7fffe0c45291 [ 0.455431] Mem abort info: [ 0.458230] ESR = 0x96000004 [ 0.461340] EC = 0x25: DABT (current EL), IL = 32 bits [ 0.466675] SET = 0, FnV = 0 [ 0.469734] EA = 0, S1PTW = 0 [ 0.472895] Data abort info: [ 0.475794] ISV = 0, ISS = 0x00000004 [ 0.479652] CM = 0, WnR = 0 [ 0.482651] swapper pgtable: 4k pages, 48-bit VAs, pgdp=0000000081694000 [ 0.489402] [ffff7fffe0c45291] pgd=0000000000000000, p4d=0000000000000000 [ 0.496230] Internal error: Oops: 0000000096000004 [#1] PREEMPT SMP [ 0.502508] Modules linked in: [ 0.505579] CPU: 0 PID: 1 Comm: swapper/0 Not tainted 5.10.238-at0 #1 [ 0.512039] Hardware name: Atmark-Techno Armadillo-IoT Gateway A9E Board (DT) [ 0.519195] pstate: 00000005 (nzcv daif -PAN -UAO -TCO BTYPE=--) [ 0.525223] pc : rproc_handle_resources.constprop.0+0x94/0x168 [ 0.531074] lr : rproc_boot+0x3b0/0x540 [ 0.534913] sp : ffff80001002b8f0 [ 0.538236] x29: ffff80001002b8f0 x28: ffffd54a0ade9868 [ 0.543568] x27: 0000000000000006 x26: ffffffffd050d291 [ 0.548899] x25: ffff800010738000 x24: ffffd54a0ade8b58 [ 0.554227] x23: ffff4faa4472a038 x22: 0000000000000000 [ 0.559558] x21: ffffd54a0b1c0248 x20: ffff4faa4472a000 [ 0.564890] x19: 0000000000000000 x18: 0000000000000038 [ 0.570216] x17: 0000000023a1f990 x16: 00000000574bc01f [ 0.575546] x15: fffffffffffe3b28 x14: ffffd54a0b0d4178 [ 0.580879] x13: 00000000000000f6 x12: ffff80001002b590 [ 0.586214] x11: ffffd54a0b12c1a0 x10: 00000000fffff000 [ 0.591548] x9 : ffffd54a0b12c1a0 x8 : ffffd54a0b0d41a0 [ 0.596879] x7 : ffffd54a0b12c1a0 x6 : 0000000000000000 [ 0.602215] x5 : 0000000000000000 x4 : 0000000000000000 [ 0.607550] x3 : 000000002faf316b x2 : 00000000d050d291 [ 0.612883] x1 : ffff7fffe0c45295 x0 : ffff800010738000 [ 0.618219] Call trace: [ 0.620676] rproc_handle_resources.constprop.0+0x94/0x168 [ 0.626167] rproc_boot+0x3b0/0x540 [ 0.629665] rproc_add+0x90/0x15c [ 0.632990] imx_rproc_probe+0x3ec/0x9ac [ 0.636925] platform_drv_probe+0x54/0xac [ 0.640942] really_probe+0xf0/0x4c0 [ 0.644530] driver_probe_device+0x58/0xec [ 0.648636] device_driver_attach+0xc0/0xd0 [ 0.652830] __driver_attach+0x68/0x130 [ 0.656681] bus_for_each_dev+0x70/0xd0 [ 0.660523] driver_attach+0x24/0x30 [ 0.664106] bus_add_driver+0x108/0x1fc [ 0.667949] driver_register+0x78/0x130 [ 0.671792] __platform_driver_register+0x48/0x54 [ 0.676509] imx_rproc_driver_init+0x1c/0x28 [ 0.680785] do_one_initcall+0x50/0x1c0 [ 0.684629] kernel_init_freeable+0x21c/0x280 [ 0.688994] kernel_init+0x14/0x11c [ 0.692489] ret_from_fork+0x10/0x38 [ 0.696078] Code: 128002b3 912c8021 97ffcef4 1400002e (b87a6b20) [ 0.702194] ---[ end trace 0b71627ff3ab9fef ]--- [ 0.706867] Kernel panic - not syncing: Attempted to kill init! exitcode=0x0000000b [ 0.714542] SMP: stopping secondary CPUs [ 0.718493] Kernel Offset: 0x5549f9c00000 from 0xffff800010000000 [ 0.724598] PHYS_OFFSET: 0xffffb05640000000 [ 0.728791] CPU features: 0x00000002,00802008 [ 0.733155] Memory Limit: none [ 0.736226] ---[ end Kernel panic - not syncing: Attempted to kill init! exitcode=0x0000000b ]---